how do you change a starter on a 2008 honda accord

Changing the starter on the Accord can be done from under the car or from the top of the engine compartment, and the procedure is similar for all of the Accord engines. Step 1 Disconnect the negative battery cable from the negative battery post with a wrench and isolate it from the battery while you are working. Step 2

Full Answer

How much does it cost to replace a starter in a Honda Accord?

Beside this, how much does it cost to replace a starter on a 2008 Honda Accord? The average cost for a Honda Accord starter replacement is between $580 and $686. Labor costs are estimated between $89 and $113 while parts are priced between $491 and $573.

How to replace the starter in your Honda Accord?

 · About Press Copyright Contact us Creators Advertise Developers Terms Privacy Policy & Safety How YouTube works Test new features Press Copyright Contact us Creators ...

How do you replace the transmission on a Honda Accord?

Disconnect the battery ground. Disconnect the starter wires. Unbolt the starter from the block by using a wrench. Hold on to it in order to keep it from dropping on you. Use paint or chalk to …

How to replace the motor mount on a Honda Accord?

Changing the starter on the Accord can be done from under the car or from the top of the engine compartment, and the procedure is similar for all of the Accord engines. Step 1 Disconnect the …

Where is the starter located in a Honda Accord 2008?

The 2008 Honda Accord starter location is right above the transmission. This piece of equipment will eventually become useless at some point. The battery will need to be replaced every 50,000 to 60,000 miles. It may coSTSome money, but You will have to cough up the cash to keep Your car running.

How much does it cost to replace a starter on a 2008 Honda Accord?

between $546 and $755Honda Accord Starter Replacement Cost Estimate. The average cost for a Honda Accord starter replacement is between $546 and $755. Labor costs are estimated between $116 and $146 while parts are priced between $430 and $609.

Where is the starter located on Honda Accord?

Locate the starter at the front of the engine compartment. It is placed near the bottom of the engine block. Remove the two electrical connections from the back of the starter with a wrench and set them aside.

Is it easy to replace a starter in a Honda?

If you need to replace the starter, you will find it to be moderately easy to take it out and reinstall. It is held in place by three bolts and mounted on the top by the firewall. Do not start working on the starter until the vehicle is cool to the touch because you will be near the engine and exhaust.

How do I know if my starter is bad?

Still, look for these seven symptoms that your starter is going bad.#1: Engine Won't Turn Over. ... #2: Noise - Clicking, Grinding, or Whirring. ... #3: Intermittent Issues Starting the Vehicle. ... #4: Starter Stays On After Starting. ... #5: Smoke. ... #6: Starter Engages But Motor Won't Start. ... #7: Battery.

How long does a starter take to replace?

between 2 and 4 hoursHow long does it take to replace a starter motor? Depending on the type of vehicle, typically a starter motor replacement will take a mechanic between 2 and 4 hours to complete from start to finish.

How do you test a starter to see if it's good?

9:3014:58How to Test and Troubleshoot a Starter Problem - YouTubeYouTubeStart of suggested clipEnd of suggested clipThe positive cable goes on its starter. Then we're to crank the engine the positive side crankingMoreThe positive cable goes on its starter. Then we're to crank the engine the positive side cranking test you don't want to see any more than 0.7 volts here. So if you see more than 0.7 volts here then.

How long does a starter last on a Honda Accord?

between 100,000 and 150,000 milesOn average, your car starter motor should last between 100,000 and 150,000 miles.

What is the cost of replacing a starter?

A brand new starter could cost you around $50 – $350, while labor costs from a qualified mechanic could range between $150 – $1,100. In total, replacing a bad starter motor could amount to between $200 – $1450. However, these figures could be lower if you're able to identify car starter issues early.

How do you test a car starter?

The easiest way to check the starter on the vehicle is to use jumper cables to bypass the vehicle's electrical system. With the ignition turned off and the transmission in "park" -- and with all due care -- connect one end of the red/positive jumper cable to the positive terminal of the battery.

Where is the starter located?

The Starter is located on the driver's side of a vehicle between the transmission and the vehicle's engine, beneath the left mound of cylinders. It is attached to the mounting plates and is held by a few bolts. It also has two wires running to it. Starter enables your car engine to start and function properly.

How do you change a car starter?

How to Replace a StarterSafety First. Disconnect the battery. ... Remove the Wiring. Remove the wiring and positive battery cable from the starter solenoid.Remove the Starter and Bolts. Remove the starter retaining bolts. ... Compare to Verify. ... Transfer Heat Shield. ... Replace with New Starter. ... Secure and Tighten. ... Connect the Wiring.More items...

Why does my starter make a clicking sound?

A clicking sound without the whirring noises from the starter would indicate a solenoid or battery problem. You can test the battery with an Ohmmeter - it should be putting out 10 volts, at the least. If it is not doing that, then the battery is the problem.

How to keep a car from dropping on you?

Place the vehicle on a smooth, dry surface where you can jack it up and safely work under it. Disconnect the battery ground. Disconnect the starter wires. Unbolt the starter from the block by using a wrench. Hold on to it in order to keep it from dropping on you.

How many bolts are needed to replace a starter?

If you need to replace the starter, you will find it to be moderately easy to take it out and reinstall. It is held in place by three bolts and mounted on the top by the firewall.

What to do if you run into problems with your Honda?

If you run into any problems or cannot solve the issue, then contact your local Honda dealership for assistance. Remember to always use real Honda parts during replacement to avoid premature failure and damage to other components.

How to check ring gears?

Use paint or chalk to mark the ring gear points and the equivalent spot on the hole. Turn the engine one full revolution with a screwdriver while checking the ring gear’s teeth.

What is bentix gear?

Generally, the problem is the bendix gear, which is the armature that presses it in and releases it from the ring gear. Rather than trying to fix a problem on a starter, it is just as cost effective to replace it. In order to install the replacement starter, reverse the removal steps.

Can starter relays wear?

The contacts in the starter relay can wear or corrode. Starter motors themselves can overheat if used for more than a few seconds at a time, windings can develop dead spots, the pinion gear that engages and disengages the starter motor can fail, etc.

What does a starter do on a Honda accord?

The vehicle starter turns the engine when the ignition key is turned on. Hence the starter requires a lot of electric current from the battery so that its gear wheel (pinion) can engage the engine's flywheel. Those charged electric motions make your Honda Accord starter susceptible to mechanical damage. Other damage to the starter can be caused by ...

Why does my Honda accord have a bad starter?

Those charged electric motions make your Honda Accord starter susceptible to mechanical damage. Other damage to the starter can be caused by leaks in the engine, kick backs, loose electrical connections and mountings, and melted starter terminals due to prolonged engine cranking.

How to remove intake manifold?

You may not find this to be enough working space, in which case the intake manifold can be removed. Using the 10mm and 14mm socket, remove all of the necessary bolts for the manifold. The throttle body can be left on the manifold. This allows access to the starter's two parallel bolts.

How to free a starter?

Remove the two parallel bolts and the plug connected to the starter's solenoid. Doing so completely frees the starter.

Can you replace a starter on a Honda accord?

Should your Honda Accord starter fail, here is how to replace it yourself. There are gains and risks to doing so, but this DIY job definitely saves you money.

How to tell if Honda Accord starter is bad?

Bad Starter Symptoms: Honda Accord. Noises coming from the starter and the vehicle itself not starting are the most common symptoms of a bad starter in your Accord. 1. Noises. Your ears are the best diagnostic tool that you have. You can tell a lot about what’s going on with a vehicle by carefully listening for changes.

What happens if the dash lights on my Honda accord turn off?

Bad Battery Cables or Terminals – Throughout your Accord’s life, the battery cables and terminals can become corroded. This corrosion keeps the proper voltage from getting to the starter. If the dash lights dim or turn off entirely when trying to start your Accord, that can indicate the battery or cables.

Why does my Honda accord make a whirring sound?

If you hear a high pitched whirring sound, it may indicate that your Accord’s starter is bad, or it could mean that the starter is turning, but not making contact with the flywheel. This is often caused by starter bolts that were not torqued tightly enough, or a broken flex plate/flywheel tooth. 2. Won’t Start.

What to do if your accord battery is corroded?

You’ll want to take a look at your Accord’s battery cables and battery posts. If they are corroded, you’ll need a good wire brush or terminal cleaner to them cleaned up.

What does it mean when your Accord starts smoking?

Smoke coming from under the hood is a good indication that the starter has given up the ghost. It can burn up, or the wiring associated with it can burn up. If you see smoke, stop cranking! Make sure your Accord isn’t on fire and have a mechanic take a look.

Anonymous

i haven't fixed the problem but I don't have any money to pay for a plan on here. thank you anyway.

Thomas Kessenich

If they are disc brakes, if the cups have slots, holes, or any thing other then flat then you need to turn them in. ( They do not push in.) They are part of your emergency brakes. You need a tool to turn them back in. You can buy one at the parts store.

Anonymous

Detach the cable from the negative terminal of the battery. Caution: If you have an anti-theft radio, make sure you have the activation code before disconnecting the battery.

ZJ Limited

Scanned the PCM in order to know what fault code is stored there; note it and send us for additional details.

Step 1 – Disconnect The Battery

Step 2 – Remove The Air Intake

Step 3 – Remove The Starter

Step 4 – Install The New Starter

• Get the new starter and plug it into the motor using the sockets and wrench. Then, fix back the intake and hoses in the order of how each part was removed but in reverse order. Lastly, plug back the negative terminal. Test that the starting issue has been solved, and let the car run while listening around the engine bay for any possible vacuum leak...

See more on honda-tech.com

Related Discussions