Receiving Helpdesk

how do you flush the radiator on a dodge ram 1500

by Euna Rippin Published 3 years ago Updated 2 years ago

Put the radiator in a vat of special heated fluid Then use a flat metal rod down through each of the radiator tubes. Then they put the radiator back into the tank of fluid & then apply Air & water pressure to blow out the crud.

Full Answer

What does a radiator flush do on a Dodge Ram?

The radiator is designed to keep the Dodge Ram's monstrous engine cool. It circulates coolant through the engine to ensure it stays cool under any driving condition. After a while, rust and deposits start building up inside the radiator. Flushing the system ensures it stays lubricated, rust free, and without contaminants.

How to drain the radiator on a Dodge Ram?

Locate the radiator's drain valve on the bottom of the radiator. You don't need to raise the Dodge Ram since it's a high truck with enough room for this job. Place a tray underneath the drain plug. Then, using your wrench, loosen the drain valve. Let it drain until it's empty.

How to change the coolant in a Dodge Ram?

You don't need to raise the Dodge Ram since it's a high truck with enough room for this job. Place a tray underneath the drain plug. Then, using your wrench, loosen the drain valve. Let it drain until it's empty. After you dispose the old coolant, close the drain plug and fill the radiator with distilled water.

How do you drain the radiator on a Ford Explorer?

Begin draining the water out of the radiator just like before as well as the heater core hoses, lower radiator hose, and remove the thermostat housing bleeder plug again. Let everything drain and then move to the passengers side block drain.

How do you flush the radiator on a Dodge Ram?

0:274:54RAM 1500 Coolant Flush Replacement - 2009 to 2018YouTubeStart of suggested clipEnd of suggested clipThere's a nice drain bolt and you put a hose on it and you can drain it into a a can or some sort ofMoreThere's a nice drain bolt and you put a hose on it and you can drain it into a a can or some sort of container. And you can actually reuse. It if you're replacing the thermostat.

How do you drain the radiator fluid on a Dodge Ram 1500?

2:2410:28How To Drain & Fill Coolant + Thermostat - Chrysler 4.7L (Dakota ...YouTubeStart of suggested clipEnd of suggested clipThe radiator cap now they have access and you have a hose on the spout. So you take a pair of pliersMoreThe radiator cap now they have access and you have a hose on the spout. So you take a pair of pliers. And turn it counterclockwise. It's hard to do with just one hand.

How do I flush my radiator myself?

Remove the radiator cap and pour distilled water into the radiator until full. Replace the cap, then start up the vehicle and let it run for 10 to 15 minutes. This will work the distilled water into the engine, flushing out any loose debris or corrosion along with the last of the old antifreeze.

Do you flush radiator with car running?

Never start work on a cooling system flush when the engine is still hot or even warm. Coolant/antifreeze can be extremely hot, and will retain its heat for hours after the engine was last running. You'll find it easier to get at the radiator drainage point (under the car) if you jack up the front two wheels.

How do you bleed a 5.7 Hemi cooling system?

1:229:53More than one way to bleed a Hemi coolant system - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo you don't have to risk burning. Yourself on anything hot with the bleeder removed you're going toMoreSo you don't have to risk burning. Yourself on anything hot with the bleeder removed you're going to add cohan to either the radiator or the pressure tank.

How much antifreeze does a Ram 1500 hold?

(1) Includes 0.9L (1.0 quarts) for coolant reservoir. (2) If equipped with Trac-lok add 0.25 pints (118mL) of Limited Slip Additive. (3) Dry fill capacity depending on type and size of internal cooler, length and inside diameter of cooler lines, or use of an auxiliary cooler, these figures may vary.

Do you have to remove thermostat to flush coolant?

No, it is not necessary to remove the thermostat. In fact, some cars you don't want to remove the thermostat while running the vehicle. The reason for this is that the thermostat can be used to direct coolant flow. If it is out, parts of the engine may not be getting coolant as designed.

Can flushing a radiator cause problems?

Can a radiator flush cause problems? Yes and no. Yes, because a radiator flush is going to flush out any corrosion, debris, rust, and other contaminants. If the flush isn't thoroughly to clear all of that out, it can loosen up those things which could clog up the cooling system, including the radiator.

How do you know if your radiator is clogged up?

5 Signs That Tell You Your Radiator Is CloggedLeaking coolant. Scroll to continue with content. ... Discolored and thicker coolant. You know your coolant's original color, don't you? ... Damaged water pump. ... Excessively high gauge temperature readings. ... Blocked, bent, or damaged radiator fins.

How long can you leave radiator flush in?

Let your engine idle with the radiator flush inside for at least 10 minutes, but time and weather permitting run your vehicle for 3-6 hours with the radiator flush and water solution in your cooling system. This will provide a deep clean and restore your cooling system to top efficiency.

What happens if you don't flush coolant?

When your radiator coolant hasn't been changed in a long time, it can cause radiator corrosion, generating rust, or debris that you do not want in your car's radiator and engine. To solve this problem, a coolant flush can prevent and clean your cooling system.

How much should a radiator flush cost?

The average cost to flush coolant from a radiator is anywhere from $100 to $200. The exact cost will usually depend on where you go (an independent mechanic will be cheaper than a dealership). Some less reputable shops might only charge between $50 and $100.

What is a radiator on a Dodge Ram?

The radiator is designed to keep the Dodge Ram's monstrous engine cool. It circulates coolant through the engine to ensure it stays cool under any driving condition. After a while, rust and deposits start building up inside the radiator.

How to get rid of old coolant in radiator?

After you dispose the old coolant, close the drain plug and fill the radiator with distilled water. Once again, open the drain valve and let the water drain out of the radiator. Repeat this process at least three times. Be sure to watch the water draining out of the radiator.

How to remove radiator cap on a truck?

Step 1 – Remove radiator cap. Park on a leveled ground, open the hood, and remove the radiator cap. It's located in the front of the car on top of the radiator. Figure 1. Make sure the truck is cool before opening the cap.

How to bleed air in a truck?

Keep the radiator cap off to bleed any air in the system. Start your truck and let it warm up for a minute or two. Watch the fluid. If it goes down, refill it to the same level. Close the cap on the radiator, make sure it's tight, and put the hood down.

What to do before removing radiator cap?

Before removing the radiator cap, be sure to put your hand on top of the engine to check if it is hot. If you can't touch the engine, the coolant inside the engine is too hot and will burn you. Don't ever open it when the engine is hot.

Can you drain a radiator yourself?

The process is simple and doing it yourself could save you a good amount of money. You will need to drain the radiator and fill it with distilled water, then drain it again a few times more. It's one of the most underrated maintenance you can do for your truck, and the benefit is remarkable.

How to fill a radiator with 50/50?

Refill with 50/50 mix until the radiator is full. Check to make sure there's heat in the cab. Once the radiator is full and its mostly done bubb ling, remove the spill proof funnel and put the radiator cap on. Check for leaks at all the hoses and drain plugs. Go for a short drive to circulate and mix the coolant.

How much coolant does a radiator hold?

The radiator holds about 2 gallons of coolant so plan your containers accordingly. Next go to the thermostat housing. This would be a great time to change your thermostat since you will be taking the housing off the water pump. Loosen the bolts on the water pump and remove the housing from the water pump.

How to cool down a truck?

Start the truck and let it idle. Fill the radiator with coolant until its full. Let the truck heat up to 203* (or less if you have a different thermostat) so the thermostat will open. When it does it will suck all the coolant down. Refill with 50/50 mix until the radiator is full.

2009 Dodge Ram 1500 SLT

Bought my third vehicle here. I see all these negative reviews but for some one who actually takes the time to read them they are unjust. Abdul helped me buy all three and was honest and open with all the issues every single car and truck had.

1999 Dodge Ram 1500 ST Quad Cab

I have bought several cars over the years due to family dynamics frank and staff are excellent.today I am bringing a friend to finance a truck fingers crossed.

2011 Dodge Ram 1500 ST

I came here to buy my first car and was dealing with Gary he was honest from the beginning he really help me with my purchase and I didn't have insurance and the young lady who works there help me get cheap insurance I would definitely recommend this dealership.

2011 Dodge Ram 1500 Sport

I purchased my Saab Convertible from GT Motors ten days ago, and developed a very high opinion for Izzy and John at GT Motors. Saabs are a rare breed (as are us Saab owners) so my search went far and wide, both interns of location of the car and internet sites used. From the get go, I was impressed by the presentation offered by GT.

2007 Dodge Ram 1500

What a fantastic truck. This truck just does everything right . Mine is a 5.7 Hemi that sounds incredible. Power is very good, although not as strong or fast as my 2014 5.0 F150. Roomy and comfortable and smooth as silk on the road. However since the 5.7 hemi screams with testosterone building induction and exhaust noise, it's loud.

2006 Dodge Ram 1500 Laramie

This truck never left me stranded. electronics are not dodges strong point lots of little anoying problems with the electronics but the hemi engine and 5 speed tranny never gave up.

2011 Dodge Ram 1500 ST

Only thing that cause a slight issue is the touch screen on radio doesn’t respond to anything. Changes must be made manually not a huge deal though

image
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z 1 2 3 4 5 6 7 8 9