What does a fuel pipe do?
A fuel line is a hose or pipe used to transfer fuel from one point in a vehicle to another. The United States Environmental Protection Agency defines a fuel line as "all hoses or tubing designed to contain liquid fuel or fuel vapor.
What size are motorcycle fuel lines?
A little over 2" long and 7/8" diameter. Outer diameter of the barb fitting is 8mm. Clear high impact polymer housing with sintered bronze element. Resistant to all standard fuel.
How do you size a fuel pipe?
Fuel pumps are sized to feed your system with enough fuel to optimize engine performance....Recommended Size, Based on Horsepower.Recommended Fuel Line Size (from the tank to the pump)Engine OutputSize (inches)Size (AN)350 hp or less5/16 in.-5350-450 hp3/8 in.-6450-650 hp1/2 in.-81 more row•Sep 16, 2017
What is the best metal for fuel line?
Most cars come from the factory with Metal Lines because they hold up better than any soft material. They are usually made from stainless, aluminum or coated steel tube. Metal is the best material for fuel lines. However, it can be difficult to fabricate.
What size is Yamaha fuel line?
Yamaha O/B Standard Fuel Line, Quick Connect, Female w/Round Post, 6' x 3/8"Compatibility93806YLP7Inside Diameter3/8 InchOutside Diameter11/16 InchMaximum Continuous Length6 FootTypeFuel Tank Lines
What size is Honda fuel line?
Genuine Honda black fuel line. Sold as a 5' foot length. This is the stock size fuel line that was used on many of the 60's-80's Honda twins and singles and fours including the CB160, CB175, CB350K, CB/CL450K, CB550 and CB750.
Does fuel line size affect pressure?
Shows the relationship between measured pressure drop as a function of flow rate, for four different fuel lines (two different sizes at two different lengths). Every fuel line experiences pressure loss depending on fuel line length, and fuel flow rate.
How do you make a fuel pipe?
2:569:17How to Flare Brake or Fuel Lines | Hagerty DIY - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo to start with using a tubing cutter. You'll set the line inside of it and then tighten it downMoreSo to start with using a tubing cutter. You'll set the line inside of it and then tighten it down until the cutting wheel makes contact with the hard line that you're bending.
How much HP can fuel line support?
A 3/8”id fuel line can easily support 600 HP given sufficient “pump head”! Given a big enough pump a 3/8” steel line could support 1000 HP. The simple way to know is to install an electronic fuel pressure gauge. If the pressure falls as the engine RPM's go up you need more pump head.
What is best material for fuel line?
The best fuel line material depends on your needs. However, the best material for fuel lines is polytetrafluoroethylene or PTFE. PTFE fuel line is made of plastic material specifically known as Teflon. This fuel line material is impervious is resistant to the degenerative fuel effects which could form vapor barriers.
What is the best type of fuel line?
The best solution is a material called PTFE. That stands for polytetrafluoroethylene—a plastic material that is best known as Teflon in one specific variation. This material is impervious to the degenerative effects of fuel that also creates a vapor barrier so fuel vapors cannot leak past.
Can I use rubber fuel lines?
Standard rubber vacuum or heater hose should never be used in fuel applications. The hose will deteriorate from the inside out and can plug fuel filters and carburetors with rubber debris, long before it springs an external leak.