Who should remove a lockout/tagout quizlet?
a lockout device should be removed only by the worker who placed it in position.
Who should remove a lock or tag once the work has been performed?
OSHA Standard 1910.147(e)(2)(i) The work area shall be checked to ensure that all employees have been safely positioned or removed. To make sure lockout/tagout removal is performed safely, each lock and tag should be removed from each energy isolating device by the employee who applied them.
Who can remove energy control lockout device quizlet?
Who can remove Lockout/Tagout devices? Designated Personnel and 7 levels. Whenever a conductor carries an alternating current.
When can another employee lockout lock be removed quizlet?
Before any preventative maintenance or servicing is performed, the equipment is either locked out or tagged out. Lockout/tagout devices applied by one employee can be removed by another employee. Lockout/tagout devices must be installed by every authorized employee involved in the work.
Who may remove a lockout tagout?
4. Remove Lockout Tagout Devices: The Lockout Tagout devices are finally removed from an energy isolating device, only by the worker who applied it. The removal of employees lock without his knowledge can be dangerous, as a general rule, the Lockout Tagout device should be removed by the employee himself/herself.
Who is allowed to remove the lock on a device?
Note: ONLY the authorized individual who placed the lock and tag onto the system is the one who is permitted to remove them. This procedure helps make sure the system cannot be started up without the authorized individual's knowledge.
Can tagout be removed by anyone?
Lockout or tagout device removal: Each lockout or tagout device must be removed from the energy-isolating device by the employee who applied the device [29 CFR 1910.147(e)(3)].
Which of the following does not apply to lock out/tag out?
Reply: The lockout/tagout requirements of Section 1910.147 do not apply to cord and plug connected equipment if the equipment is unplugged and the plug is in the exclusive control of the employee who is performing the servicing or maintenance of that equipment.
What is lockout/tagout quizlet?
Group Lockout/Tagout. refers to a leader locking/tagging out for workers under his or her immediate control on the same work crew. Hazardous Energy Sources. Electrical, mechanical, hydraulic, pneumatic, and chemical. Lockout.
Who gets the locks from the Loto coordinators?
LOTO Coordinator performs a pre-job briefing with the third-party qualified person. Third-party qualified person secures lockbox (hasp or satellite as needed) behind the coordinator lock with a non-listed (Non-listed visitor or Contractor) lock.
When would you see one employee placing his lock on the isolating device before another removes his own device?
All authorized employees shall affix their personal lock to the group lockout device when they begin work and shall remove their lock when they stop working on the machinery or equipment being maintained, serviced or cleaned, this includes but is not limited to, lunch breaks, bathroom breaks and shift change.
Which government entity establishes the requirements for Lockout/Tagout quizlet?
SUMMARY: The control of hazardous energy is regulated under OSHA's control of hazardous energy (Lockout/Tagout) standard. The standard's purpose is to protect workers from the dangers of hazardous energy.