The following steps should be used to reset your Whirlpool washing machine:
- Turn off the washer.
- Turn the mode dial to NORMAL.
- Turn the dial counter-clockwise one click left, clockwise three clicks, counterclockwise one click, and then clockwise one click.
How do you unlock a whirlpool duet washer?
You can manually unlock the washer by removing the top (remove screws on the back of the top panel and slide the top panel back to lift off. How to unlock the controls for a whirlpool duet washer. Hold down the “control lock” button on your whirlpool washer for three seconds at the end of the washing cycle.
How to clear Whirlpool duet error?
- Write the error code down so you won't forget it after it is cleared.
- Press the "Pause/Cancel" button on the control panel twice to clear the error.
- Contact a certified repair technician if pressing the "Pause/Cancel" button does not clear the error, as this indicates that a component has failed in the washing machine or dryer. ...
How do I Reset my Whirlpool fully automatic washing machine?
- Washer Won't Pump or Spin. It may happen that the washing machine fails to pump water in and out, as well as spin.
- Pumps, but Won't Spin.
- Washer Won't Agitate.
- Clothes Still Wet.
- Problems in Every Cycle.
How to fix Whirlpool duet "Sud" message?
• If too much detergent was used, run the unit through a Rinse/Spin cycle then a Normal cycle without adding any detergent. This should clear the unit of the excess detergent. • Check CCU Replace failed component. To access the pressure switch, take the top off the machine by removing the 3 screws along the rear lip.
Steps to Reset a Whirlpool Washing Machine
The following steps should be used to reset your Whirlpool washing machine:
How to Confirm You Have Reset Your Whirlpool Washing Machine
Once you have taken the above steps, press the START button. Are all the cycle indicating lights illuminated? If they are, press START / STOP one time. Rotate your dial until you have the following three lights illuminated: RINSE, WASH, and STOP. Then turn off your washer and unplug it for ten seconds. When you turn it back on it should be reset.
Try the Cabrio Reset Procedure
If your washer is still not working correctly, you can try the Cabrio reset procedure. Touch any button that you see on your display pad. This will clear the error code. Or you can press PAUSE/CANCEL. Choose a cycle and press START.
Method 1: Unplug the Washing Machine
The most common way to reset a Whirlpool washing machine is to disconnect the power to the washing machine. The reset works by allowing the electrical charge to dissipate from the washing machine, which allows it to reset. If the reset fails, try again, but double the amount of time that you need to wait.
Method 2: Reset the Circuit Breaker
If you cannot unplug the washing machine, the power can also be disconnected by resetting the circuit breaker in your home’s electrical panel.
Method 3: Press a Combination of Buttons
Some Whirlpool models require a combination of buttons to be pressed or held to reset the washer. Finding the washing machine’s manual is the best way to find out which buttons need to be pressed to reset it. If you cannot find the manual, pressing a combination of the Pause/Cancel and Power buttons may work for your Whirlpool model.
Method 3: Turn the Dial
If the washing machine has a dial on the control panel, you may be able to reset the machine by following the instructions below.
Method 4: Open and Close the Lid
If you have a top-loader Whirlpool washing machine, you may need to open and close the lid to reset the washing machine.
Method 5: Press the Power and Program Buttons
If the above reset methods have failed to work for you, you may be able to reset your model by pressing the following buttons: Power, Program, and Water Level. After pressing these buttons, the washing machine’s lid needs to be opened and closed.