How do you change the batteries in a zircon stud finder?
0:351:23How to Change the Batteries in your Zircon Stud Finder - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo all you have to do is lift up the tab at the bottom of the tool replace. The battery and snap theMoreSo all you have to do is lift up the tab at the bottom of the tool replace. The battery and snap the cover back into place.
Why is my Zircon stud finder not working?
1) Check Your Battery. If your stud finder worked previously, but no longer seems to work, about 9 times out of 10, the problem is a weak battery. You may swear that the battery is still good, but it's not. Compared to garage doors and many other devices, stud finders require a very strong battery.May 27, 2020
What do the lights on a Zircon stud finder mean?
0:001:31How to Use a Zircon StudSensor EDGE Stud Finder to Find Wall StudsYouTubeStart of suggested clipEnd of suggested clipIf you happen to start scanning over a stud and move away the units lights will blink to indicate aMoreIf you happen to start scanning over a stud and move away the units lights will blink to indicate a calibration error. Simply move the tool a few inches to either side and turn it on again.
What does beeping on Zircon stud finder mean?
If the tool blinks and beeps continuously, there is a calibration error. Try scanning the wall again, but start in a different location. • Use DeepScan® mode only if you need it. Using this feature on a regular thickness wall will cause the unit to read studs a bit too wide.Apr 8, 2015
What battery does a Zircon StudSensor use?
Most Zircon StudSensor ™ and MultiScanner ® stud finders require one brand new alkaline 9V battery (with an extended expiration date) for proper operation. Please be sure to refer to the instructions for the specific model you have.
How to use Zircon stud finder?
Zircon stud finders are designed to be as effortless as possible. Place the stud finder flat against the wall, press and hold the power button, and wait for 1-2 seconds. The tool automatically calibrates to the wall’s surface.
How to tell if a stud is metal?
To verify whether the stud you located in Stud Scan or DeepScan ® mode is metal or wood, you would need a MultiScanner ® stud finder with Metal Scan mode (or a dedicated metal finder). Switch the mode to Metal Scan and scan the stud again. If you receive positive metal indications from floor to ceiling, the stud you located is metal. Intermittent metal indications from floor to ceiling are likely nails or screws. (This mode will only detect the presence of metal.)
What is Zircon metal scanner?
Note: The Metal Scan mode in Zircon MultiScanner tools are only designed for detecting metal close to wall surfaces, such as nail heads and joist brackets. It is not designed for locating pipes contained within walls or under floors. Please refer to the Zircon MetalliScanner ® MT 6 metal locator for more information for those applications.
How long does Zircon warranty last?
Zircon Corporation (“Zircon”) warrants products to be free from defects in materials and workmanship for two years from the date of purchase.
What is the hole in a battery spacer?
Check that the battery spacer (the plastic part with two holes) is sitting in front of the battery contacts. The smaller hole is the “+” terminal and the larger hole is the “-” terminal.
Can Zircon StudSensor be used on plaster walls?
Basic Zircon StudSensor ™ stud finders with only Stud Scan and/or DeepScan ® mode are not recommended for lath and plaster walls.