What does it mean when your Kenwood radio says protect? "Protect" is an indicator that there are either shorted speaker outputs inside the unit, a shorted speaker wire, or a blown speaker connected to the unit. If you've pressed the reset button, and it's still in "Protect", then disconnect all of the speaker wires connected to the head unit.
What does protect mean on a Kenwood stereo?
Why does a Kenwood radio say protect? " Protect " is an indicator that there are either shorted speaker outputs inside the unit, a shorted speaker wire, or a blown speaker connected to the unit. If you've pressed the reset button, and it's still in " Protect ", then disconnect all of the speaker wires connected to the head unit.
What does it mean when it says protect on my speaker?
15/02/2020 · What does it mean when your Kenwood radio says protect? "Protect" is an indicator that there are either shorted speaker outputs inside the unit, a shorted speaker wire, or a blown speaker connected to the unit. If you've pressed the reset button, and it's still in "Protect", then disconnect all of the speaker wires connected to the head unit.
Why won't my Kenwood head unit turn on?
02/05/2011 · This issue comes up very often regarding these systems. "Protect" is an indicator that there are either shorted speaker outputs inside the unit, a shorted speaker wire, or a blown speaker connected to the unit. If you've pressed the reset button, and it's still in "Protect", then disconnect all of the speaker wires connected to the head unit.
Is my Kenwood KDC-x498 on Protect Mode?
Kenwood equips its receivers with a protection mode to safeguard them. Your stereo receiver is going into protection mode because the receiver has an internal short, a speaker is bad or the speaker wiring has a problem, such as incorrect wire gauge or bad connections.
How do I get my Kenwood stereo out of Protect Mode?
Turn off the receiver and let it cool for a few hours; then try again. If the protection mode warning doesn't go away on its own, press the reset button. If that doesn't work, disconnect the power lead from your receiver for 30 seconds and then reconnect it. If it still doesn't work, it's time to take it to the dealer.03-Dec-2018
How do I reset my Kenwood protect?
Kenwood Factory ResetStep 1: Hold Eject CD And Volume button. On the left of the CD slot, you will find the Eject CD button. ... Step 2: Press The Reset Button. ... Step 3: Tap the “Initialize All” button. ... Step 4: Again, press the reset button.
How do you unlock a Kenwood radio?
1:132:40How to deactivate Super Lock on Kenwood two way radios | Radio 101YouTubeStart of suggested clipEnd of suggested clipYou're going to hold down side key number two and at the same time you're going to power the radioMoreYou're going to hold down side key number two and at the same time you're going to power the radio on when the orange light comes on you'll release it your 2 beeps. Power it off back on.
How do I remove a Kenwood faceplate?
0:111:20How to Remove a Kenwood Car Stereo - YouTubeYouTubeStart of suggested clipEnd of suggested clipBut on the metal just to help loosen. Until you can get a firm. Hand. Once it's unlocked remove theMoreBut on the metal just to help loosen. Until you can get a firm. Hand. Once it's unlocked remove the keys grab firmly again onto the metal versus the plastic of the stereo. And then remove.