How to Start a Murray 17Hp 42-Inch Lawn Mower
- 1.. Check the tire pressure. Place a tire pressure gauge on the valve stem of the tire. The tires should be inflated to...
- 2.. Remove the oil cap and dipstick from the tractor engine while the tractor is on level ground. The oil cap is under...
- 3.. Add SAE 30 motor oil to the oil tank if necessary, a little at a time.
How do you start a Murray lawn mower?
Starting a Murray lawnmower is like starting almost any other brand of mower. Wipe the dipstick that connects to the bottom of the cap with a clean cloth. Insert the dipstick and cap into the oil fill neck. On some models, to check the oil level, you do not thread the cap all the way; on other models, you must.
How do you start a lawn mower with a gas engine?
Push this button 3-4 times to force gasoline into the lines. Pull the throttle lever, located on the handle of the lawnmower or the body of the engine, into a mid-to-high position.
Can you use old gasoline in a Murray lawn mower?
Old gasoline can have bad effects on your Murray lawn mower. Most gasolines contain ethanol. This is a corn-based fuel that is added to gasoline to make it a more environmentally-friendly product. While gasolines with ethanol are okay to use in most vehicles, it can cause problems to the small engines used on a Murray mower.
How do you use the primer on a Murray lawn mower?
Push the primer button three times, allowing about two seconds between each push. Go behind the Murray mower. Grab the throttle lever on the handle with one hand and the handgrip of the recoil rope with your other hand. Press the throttle lever toward the handle and pull the recoil rope with a swift jerk.
How do you start a Murray riding lawn mower?
Turn the ignition key to the "start" position, all the way to the right on the ignition dial and marked by an arrow, and hold it there until the engine starts and catches, then let go. The ignition switch is on the right side of the steering wheel.
Why is my Murray lawn mower not starting?
A Murray lawn mower won't start when the fuel tank is empty; old fuel is clogging the fuel components; the spark plug is bad; the air filter is plugged; the battery is bad; the charging system is failing; the carburetor is dirty; or a switch is bad.
How do you start a gas powered lawn mower?
Step 1: Position the lawn mower. ... Step 2: Check the petrol level. ... Step 3: Check the oil level. ... Step 4: Check the spark plug. ... Step 5: Press the fuel button 3 to 5 times. ... Step 6: Put the throttle in the start position. ... Step 7: Pull the starter rope. ... Step 8: Lawn mowing!
How do you start a Murray 450 lawn mower?
0:060:40Murray 450E Push Mower - YouTubeYouTubeStart of suggested clipEnd of suggested clipE series engine offers dependable power and an exceptional value and with the prime and pull easyMoreE series engine offers dependable power and an exceptional value and with the prime and pull easy starting system you just push the primer bulb three times for easy starting.
How do you start a lawn mower that won't start?
If you run into problems getting your lawnmower ready for spring, try the following:Use fresh gas. Old gasoline can cause starting difficulties. ... Check the spark plug. ... Use the choke. ... Prime the mower. ... Check the air filter. ... Check the cables. ... Check for water in the fuel tank.Clear the starter cord of blockages.More items...
What would make your lawn mower not start?
Your Mower Won't Start:Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten.Dirty Air Filter: Clean or replace.Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas. If this doesn't work, you might need a new fuel filter.
How do you start a lawnmower that has been sitting?
0:385:22How To Start A Mower That's Been Sitting - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd we're going to spray some carburetor cleaner up there and then we're going to reseat that cup 99MoreAnd we're going to spray some carburetor cleaner up there and then we're going to reseat that cup 99% of the time that's all you need to do to fix.
Where is the choke lever on lawn mower?
There's a variety of lawn mowers, but for an internal combustion engine, the choke valve is usually located on the body of the engine or a lever on the handle. Most choke valves are butterfly valves mounted in the manifold up from the carburetor jet.
How do you start a sitting lawn mower?
0:000:37Starting a Riding Lawn Mower - YouTubeYouTubeStart of suggested clipEnd of suggested clipThen you press the key into the ignition. And then you press in the clutch all the way down and makeMoreThen you press the key into the ignition. And then you press in the clutch all the way down and make sure that your mower is in neutral. And then you turn the key to the right turning. On the mine.
How do you start a Murray 20 lawn mower?
The Murray 2-in-1, 21-inch cut gas push mower comes loaded with features that make it easier for you to maintain your lawn. Starting is a breeze with the Prime 'N Pull Easy Start System. Just prime the bulb on your mower 3 times and pull the cord for a guaranteed start.
How do you start a Briggs and Stratton engine?
To begin, simply push the primer bulb slowly three times to deliver the proper amount of fuel to the carburetor. Then, pull to start.
How do you start a Briggs and Stratton 450 Series?
Start a traditional/push Briggs & Stratton lawnmower in 7 easy steps.Step 1: Check the type of ignition system:Step 2: Get set to start the lawnmower:Step 3: Check oil and gas in your machine:Step 4: Test the spark plug:Step 5: Locate the Prime Bulb:Step 6: Open the throttle:Step 7: Pull the starter cord:More items...
Common solutions for: Murray Lawn mower won't start
Inspect the spark plug for signs of wear or damage. If the porcelain insulator is cracked, an electrode is burned away or damaged, or there is heavy carbon buildup at the electrode, replace the spark plug. To determine if the spark plug is defective, use a spark plug tester.
The Right Parts for the Job
We carry more than 4 million parts from over 175 major brands, so chances are, we've got the part you need.
Murray Fuel Tank is Empty
Murray lawn mowers require gas to run. I’m sure you already know this. I only mention it because, in the heat of the moment when you’re frustrated because your mower won’t start, you can easily forget to check for this simple requirement.
Old Fuel in a Murray Lawn Mower
Old gasoline can have bad effects on your Murray lawn mower. Most gasolines contain ethanol. This is a corn-based fuel that is added to gasoline to make it a more environmentally-friendly product. While gasolines with ethanol are okay to use in most vehicles, it can cause problems to the small engines used on a Murray mower.
Bad Spark Plug or Loose Connection on Murray Mower
The spark plug can become dirty with carbon buildup and oil. When this happens, the spark plug will misfire keeping your Murray mower from starting. Loose spark plug wires or an incorrectly gapped spark plug will also cause a starting problem.
Air Filter Plugged in a Murray Lawn Mower
The air filter is necessary to protect your engine from dirt and debris. Contaminating the engine can result in significant damage and a large repair bill. Never run your Murray lawn mower without an air filter, even for a short time.
Murray Mower Fuel Pump is Bad
A fuel pump is required when the carburetor sits above the fuel tank. If you have a push mower, you most likely won’t have a fuel pump installed. A fuel pump is used to get fuel to the carburetor. When the pump is no longer able to build pressure using the vacuum in the crankcase, it must be replaced.
Plugged Fuel Filter in Murray Lawn Mower
The fuel filter is designed to prevent dirt and debris from entering the fuel system. If the filter is plugged or cracked keeping fuel from passing through the filter, it must be replaced.
Murray Mower Has a Blockage in the Fuel Line
Old fuel sitting in your machine can develop gummy deposits that can block the fuel line. To identify a clog in the fuel line, you will need to start and stop fuel flow while you check each section of fuel line for good flow.
What is Murray mower?
Murray manufactures lawn and garden equipment including push mowers, riding mowers, blowers and trimmers. Murray mowers feature Briggs and Stratton engines. The 17-horsepower lawn tractor has a 42-inch cutting deck. Riding lawn mowers require a few more steps than just stepping on the brake and turning the key to start the engine ...
How to adjust the height of a lawn mower?
Set the attachment lift lever, located on the right side of the mower front, to the desired height for your grass. Depress the button on the top of the lever to adjust the setting.
How to remove oil cap from tractor?
Remove the oil cap and dipstick from the tractor engine while the tractor is on level ground. The oil cap is under the hood and marked. Wipe the dipstick clean with cloth. Replace the dipstick and cap, then remove it again after about five seconds. Remove the cap and dipstick again and look at the stick.
How to start a car when it doesn't start?
Turn the ignition key to the "start" position, all the way to the right on the ignition dial and marked by an arrow, and hold it there until the engine starts and catches, then let go. The ignition switch is on the right side of the steering wheel. Do not hold it in this position for more than 15 seconds at a time if the engine doesn't catch right away. Wait one minute before trying again.
Where is the reverse position on a tractor?
Move the ignition key from the regular "on" position to the "reverse" position when you want to back up. The "reverse" position is at the top of the ignition dial and shows a picture of a tractor with an arrow underneath that points toward you. Remember to move the key back to the "on" position to move forward.
What pressure should I use to inflate a tire?
The tires should be inflated to a pressure of about 30 PSI. If pressure is too high, use the pressure gauge to release some of the air from the tire. You will hear a hissing sound as the air releases. If is is too low, inflate the tire with an air compressor or tire pump.
How to start a push lawnmower
Starting a push lawn mower is not a troublesome task. However, before starting the mower, make sure that all the parts of the mower are good in condition.
How to start a riding lawnmower
Riding lawn mowers are more comfortable than the push lawnmower. But you must be careful when you start riding lawn mower because it’s a heavy machine.
How to start a push mower?
Before you start a push lawn mower, locate the prime button, which is usually a red or black button with a rubber cap located somewhere on the body of the mower. Push this button 3-4 times to force gasoline into the lines.
How to prime a carburetor on a lawn mower?
Prime the carburetor. Locate the prime button, which is usually a red or black squishy button somewhere on the mower's body. Push it between 3 and 4 times in order to force the gasoline into the lines. Don't go crazy with the squishing, or you'll flood the engine.
How to stop a lawn mower from smoking?
First, turn off your lawnmower and allow it to sit for an hour to cool off. Monitor it to make sure the smoking stops after a few minutes. Keep a fire extinguisher on hand in case of emergencies. If your lawnmower is smoking and won’t stay on, take it to a small engine a mechanic. Your mower may need servicing.
What to do if your lawnmower dies?
If your mower dies while you’re using it, you may be cutting grass that is too tall. If this is the case, raise the cutting height of your lawnmower. Refer to your user manual to do this as every lawnmower is different. Check your user manual to see if it addresses this issue.
How to keep a lawn mower from running cold?
If you skip this step, the engine won’t be able to keep going once you’ve started it. If the mower is cold, set the choke. The choke helps provide a richer fuel-air mixture to the engine, which helps it stay running until it warms up. Once the mower has been running for a few minutes turn off the choke .
Where should the spark plug end be on a motor?
There should be a single spark plug end sticking out on the back or side of the motor, with a lead that looks a thick wire with a rubber cap attached to it. This is what gets that motor running so make sure that the lead is firmly attached to the spark plug.
