How do you reset the SRS light on a 2001 Honda Accord?
- Verify and make sure the ignition is switched OFF.
- Connect the 2 pins in the MES with a paper clip or metal object.
- Turn the ignition switch ON.
- The SRS Indicator Light should come on for 6 seconds and then go off.
- The SRS Indicator Light should come back on agian.
Full Answer
How do you turn off the SRS light on a Honda Accord?
03/03/2020 · How do you reset the SRS light on a 2001 Honda Accord? -Short and hold the leads while you turn the ignition to on. The SRS Light will illuminate for a few seconds then go off.
How do I reset the SRS light?
Here’s how to reset the SRS light in your 2001 Honda Accord, step by step. Bend a paperclip into a U shape. Find the MES connector under the driver’s side dashboard on the left. It is yellow. Make sure that your ignition is off. Perform the following steps rapidly.
What causes the SRS light to turn on in a car?
14/02/2022 · -Short and hold the leads while you turn the ignition to on. The SRS Light will illuminate for a few seconds then go off. -When the SRS Light goes off, unshort the wires. The SRS Light will come back on. Re: SRS light is on - accord 2000 ex (annicus) Verify and make sure the
What is the secondary Restraint System (SRS) on a Honda Accord?
12/03/2015 · With this connection made, turn the ignition key to the "on" position (do not start the engine). The SRS will illuminate for two seconds, then turn off. When the light turns off, disconnect the shorting wire to un-short the circuit. The SRS light will turn on again. When it does, reconnect the shorting wire.
How do you turn off the SRS light on a 2001 Honda Accord?
1:001:50How to reset SRS light on 1998-2002 Honda ACCORD (J Series DIY)YouTubeStart of suggested clipEnd of suggested clipTurn off the ignition. Then you need to short the wires. Like that I cut the clip so I could connectMoreTurn off the ignition. Then you need to short the wires. Like that I cut the clip so I could connect the wires faster. I have to do it quickly so connect them first and turn on the ignition.
How do I turn off the SRS light on my Honda Accord?
How to Reset a Honda Accord SRS LightStraighten out a paperclip.Pull down on the fuse panel cover under the steering column with your fingers to remove it.Locate the small yellow plug in the fuse panel. ... Unplug the power connector from the fuse panel.More items...
What does the SRS light mean on a 2001 Honda Accord?
The SRS light is a warning light for your supplemental restraint system (airbags). An SRS light means that there is a problem in the system. The first thing I would check is the fuse for the SRS unit.11-Nov-2010
How do you turn the SRS light off?
Turning off the airbag light yourself can save you a trip to your car dealer.Turn on the ignition switch with your car key. ... Wait for the airbag warning light to turn off. ... Turn the ignition switch of your car back off for a little longer than three seconds.Repeat steps 1 through 3 twice to make three times total.
What is SRS code for Honda?
If your Honda airbag light remains on, it most likely means that the Supplemental Restraint System (SRS) has detected a problem with the airbag system. When your Honda airbag system functions properly, the airbag light comes on when you turn on the ignition but should turn off once you start the engine.
Can you drive with the SRS light on?
So is it safe to drive with an SRS light on? The answer would be no, Even though there's a possibility that the airbags could still deploy with the light on it is a huge risk if one were ever involved in an accident. We recommend having a professional look at it and diagnose the issue to have fixed immediately.13-Nov-2017
How do you reset the SRS light on a 2001 Honda Civic?
0:112:15HOW TO ERASE SRS LIGHT || HONDA CIVIC & ACURA ELYouTubeStart of suggested clipEnd of suggested clipOnce you find the yellow plug there's a button on the top of the plug. Simply push it and pull itMoreOnce you find the yellow plug there's a button on the top of the plug. Simply push it and pull it out this is supposed to come out easily.
What would cause the SRS light to come on?
If the SRS light stays on or starts flashing on and off, you may have a problem with the airbags themselves, a loose wire, a faulty seat belt buckle, or a problem with the Engine Control Unit (ECU) that is causing the airbag warning light to stay on.
What does the Red SRS light mean?
If the SRS light illuminates while you are driving, it signals there's an issue with the car's airbag system. It also means that the airbags may not deploy if you're in an accident. If the light comes on, take your car to get the SRS sensor checked as soon as possible.30-May-2020
How do I clear my SRS code?
3:495:12How to Get and Erase Airbag Trouble Codes! - 2CarPros - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd click on erase fault data I'll right-click okay diagnostic clear diagnostic codes it'sMoreAnd click on erase fault data I'll right-click okay diagnostic clear diagnostic codes it's accessible there you go and that is how you're able to clear an airbag light on your vehicle.
Can you reset airbag light without tool?
In some older cars, though, it is possible to reset the airbag light without a scanner by removing the car battery terminals. Check the wiring system underneath the driver or passenger seat for any loose wires or corrosion in the connector plug. Spray the connector plugs with an electronic cleaner and restart your car.02-Oct-2021
Will disconnecting the battery reset the airbag light?
Many air bag computers use non-volatile memory so even removing battery power won't erase them. It takes a scanner to erase them. But even if you do erase it, whatever turned the light on to begin with will turn it right back on so you accomplish nothing.
What does the SRS light mean on a Honda Civic?
The SRS light may indicate a problem with a sensor in the steering wheel, seat, or onboard computer. But even if you discover the reason for the problem, the light does not reset itself. Learn how to do so here. This article applies to the Honda Accord (1990-2002) and Honda Civic/Del Sol (1992-2000). The secondary restraint system, ...
Does the SRS light come on?
That's partially true; however, having the SRS light come on during Honda ownership is almost an expected thing. Having the SRS light come on is so common that the original owner's manual actually gives a briefing on how to reset it. To do so, you will be "shorting" the system in order to reset the light.
What is the SRS light on a Honda?
The secondary restraint system, or SRS, is a safety system in your Honda that controls the airbags, among other things. You would imagine that when the SRS light comes on, that it would be a big deal and need to be checked out immediately.
Where is the MES connector located?
Step 1 – Locate the MES. Locate the MES (Memory Erase Signal) connector. It is below the dashboard on the driver’s side of the car plugged into a panel (there is no electrical connection). Figure 1. MES location under the dash.
How to reset SRS light?
Step 1 – Reset the SRS light 1 Locate the Memory Erase Signal (MES) plug. It is under the driver's side dashboard near the fuse panel. The harness is yellow and has two wires coming out of it. 2 Disconnect the MES plug from its socket. 3 Strip each end of the speaker wires. Then, insert one end of each wire into each plug opening. If you don't have wires, you can use paperclips instead. 4 Hold the ends of both wires together, and turn on the ignition. The SRS light will come on, and after a few seconds it will turn off. Once the light turns off, pull the wires apart. The light should turn back on. 5 Hold the stripped ends of both wires together again. The SRS light should go off. When the light goes off, pull the wires apart. The SRS light should blink twice. 6 Turn off the ignition to start your car as normal. The SRS light should come on, and after a few seconds it will turn off and stay off.
Why does my car have a SRS light?
The Supplemental Restraint System (SRS) light remains on when it is indicating a problem with your car's SRS computer, airbags, the steering wheel, or the driver's seat. A problem with the car's computer often indicates that the light won’t reset on its own.
How long does the SRS light last?
The SRS light will come on for about six seconds and turn off. Then, it will come on again and flash. Take note of the flashes because this is how you’ll read the Diagnostic Trouble Codes (DTC). There may be long flashes and short flashes. For example, a long flash would indicate an error code of 10.
Step 1 – Reset The SRS Light
Step 2 – Run A Diagnostic Test
- Running a diagnostic test can help you determine why your SRS light is on. 1. Remove the glove box so you can reach the two-pin service check connector. You will also see a three-pin data-link connector close by. Do not touch this one because you may accidentally damage the ECU or engine computer. 2. Turn the ignition off. Wait 10 seconds, and connect two terminals of the ser…
Step 3 – Replace SRS Unit
- A faulty SRS unit can explain why your SRS light won't stay off, even after you try resetting it. Before replacing the entire unit, make sure all connections are tight. Loose connections can cause the SRS light to stay on as well, and tightening the connections can often resolve the issue. 1. Disconnect your battery, and wait between three to five minutes before replacing your SRS unit. …
Related Discussion and Sites