How do you remove a Pegasus shower cartridge?
- Remove the handle assemblies. Pop out the screw caps on the top of each handle with your fingers.
- Remove the Pegasus faucet cartridges. Unscrew the cartridge bonnet nuts with a crescent wench.
- Install the new Pegasus faucet cartridges.
- Reinstall the handle assemblies.
- Test the faucet's operation and check for leaks.
How do you replace a Pegasus faucet cartridge?
1 Remove the handle assemblies. Pop out the screw caps on the top of each handle with your fingers. 2 Remove the Pegasus faucet cartridges. Unscrew the cartridge bonnet nuts with a crescent wench. 3 Install the new Pegasus faucet cartridges. 4 Reinstall the handle assemblies. 5 Test the faucet's operation and check for leaks. More ...
What should I do if my Pegasus faucet has low pressure?
If your Pegasus faucet seems to have experienced a dip in water pressure, first verify that the water supply valves are open all the way and that there are no kinks in the supply lines. Then, remove the aerator from the end of the spout. Note that tub faucets typically do not have these parts.
Where is the hot water cartridge on a Pegasus faucet?
If your Pegasus faucet has separate hot and cold taps, then there's a cartridge under each one. To access the cartridge, you'll need to remove the handle. Start by turning off both the hot and cold water supply valves under the sink.
Where is the escutcheon on a Pegasus bathroom faucet?
For shower faucets, look on the round plate (escutcheon) behind the handle, on the handle itself, or perhaps on the actual valve behind the wall. Similarly one may ask, how do you fix a Pegasus bathroom faucet?
How do you remove the cartridge from a Pegasus faucet?
With the handle off, twist off the decorative neck of the faucet to reveal one or two nuts holding the cartridge in place. Use a wrench to loosen and remove these. Then, simply lift straight up on the cartridge to remove it.10-Sept-2020
How do you take apart a Pegasus bathroom faucet?
Locate the cover on the handle of the Pegasus faucet and take it off by prying it up with your fingers. Set the part aside. If the part does not com up easily, use the edge of a knife to pry it up. Unscrew the retaining screw, located on the top of the handle right in the center, with a Phillips screwdriver.21-Jul-2017
What happened to Pegasus faucets?
Because Home Depot owns Pegasus, it's the main outlet for purchasing its faucet parts. However, aside from the decorative faucet parts (called the faucet trim), most of the inner faucet parts are compatible with the same parts used in other brands.18-May-2020
How do you repair a Pegasus shower faucet?
1:023:53Pegasus Faucet - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd pull the limiter to the edge of the white spline. But do not pull it off notice that this planMoreAnd pull the limiter to the edge of the white spline. But do not pull it off notice that this plan has very small teeth. I took a marker a sharpie and marked the limiter and the shaft.
How do you remove faucet handles that have no screws?
You can use an allen wrench (also called an allen key) to remove it. Once you've done that, you can typically just lift the faucet handle off. However, if it has a cartridge inside, you may need to unscrew a top piece as well to be able to remove the cartridge.19-May-2021
What company makes Pegasus faucets?
The Home DepotPegasus Faucets are a proprietary brand owned by The Home Depot.
How do you change a shower cartridge?
2:576:30How to Replace a Delta Faucet Shower Cartridge | DIY Plumbing ...YouTubeStart of suggested clipEnd of suggested clipUse a strap wrench or a pair of channellock pliers to loosen the bonnet nut by turning itMoreUse a strap wrench or a pair of channellock pliers to loosen the bonnet nut by turning it counterclockwise then remove the bonnet nut by hand.
How do you change a bathroom faucet cartridge?
1:293:02How to Replace Leaky Cartridges in a Bathroom FaucetYouTubeStart of suggested clipEnd of suggested clipFirst align the tab on the new cartridge to the slot on the faucet. Now screw on the bonnet nut andMoreFirst align the tab on the new cartridge to the slot on the faucet. Now screw on the bonnet nut and tighten with the crescent wrench reinstall the handle and pop the caps back.
How do you remove a Danco shower cartridge?
0:312:11Repairing a Leaky Single Handle Tub/Shower Cartridge FaucetYouTubeStart of suggested clipEnd of suggested clipStop. Key stop stop to trim plate and retainer clip grasp the cartridge stem with the cartridgeMoreStop. Key stop stop to trim plate and retainer clip grasp the cartridge stem with the cartridge puller. And pull the cartridge out of the valve.