how do you put a blade on a black and decker circular saw

by Prof. Karelle Glover V Published 3 years ago Updated 3 years ago

^{How to Install the Blade of a Black and Decker’s Cordless Circular Saw}

Firstly, take the battery out of the cordless circular saw. Make sure there is no power source on any saw when you are planning to touch the blade.
Press the spindle lock under the handle and rotate the blade so it gets locked in place. ...
Take the included Allen key that is inserted into the circular saw. Use it to turn the blade retaining screw which is on the side of the blade.
Slide the blade inside the saw from underneath and fit the blade on the inner flange. After which you place the outer washer on the spindle.
Slowly use the Allen key to put the screw back on the blade and tighten it. Make sure the spindle lock is pressed when you do so.

Part of a video titled How to install a blade on Black and Decker 20 volt cordless ...

1:14

2:42

So anyway so you put the blade in here. And this isn't stopping the blade. And you push that over soMoreSo anyway so you put the blade in here. And this isn't stopping the blade. And you push that over so this thing won't be in the way and you kind of wiggle it inside of there like that.

How do you change the blade on a Black and Decker corded circular saw?

1:164:39Black and Decker Circular Saw (13 Amp Corded Model) - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd you can use the provided allen wrench to turn down on the bolt. Like so and you just want toMoreAnd you can use the provided allen wrench to turn down on the bolt. Like so and you just want to remove this bolt and the outer blade clamp washer that will allow you to swap out the blade.

Which way should a blade be installed on a circular saw?

Almost all circular saw blades have an arrow that is either printed or engraved on the blade. This arrow indicates which way the blade should be installed in the saw. The arrow needs to point towards the front of the circular saw. If we don't see an arrow the teeth need to face towards the front of the saw.

How do you change the blade on a Black & Decker 7 1 4 circular saw?

0:274:11How to Change the Blade in a Circular Saw - YouTubeYouTubeStart of suggested clipEnd of suggested clipThis gives you access to the blade to get the blade out you will need to remove the bolt from theMoreThis gives you access to the blade to get the blade out you will need to remove the bolt from the sound blade moves freely so you'll need to hold the blade in place while you loosen the bolt.

Which way should a saw blade face?

When installing a new blade, make sure the teeth are pointing downward to enable a clean cut through the workpiece. Upward-facing teeth can cause a severe injury to the operator.

Can you put a circular saw blade on backwards?

When cutting vinyl siding with a circular saw, install a fine-toothed blade backwards on the saw for a smoother, cleaner cut, especially in cold weather (when the material is brittle). Make the cut slowly.

How do you change a circular saw blade without a spindle lock?

7:419:44How to Remove Saw Blade With No Spindle Lock - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd you can hold that screwdriver against take your bolt loosen. It put your new one on go this wayMoreAnd you can hold that screwdriver against take your bolt loosen. It put your new one on go this way with your new blade tighten that up you should be all set.

How do you change the blade on a Black and Decker FireStorm saw?

How to Change the Blade on a Black & Decker FireStorm Reciprocating SawGrasp the side-mounted lever and pull up.Pull the current blade from the saw.Insert the new blade into the slot. ... Lower the side lever.Pull vigorously on the blade to check the proper seating.

Receiving Helpdesk