Open by Drilling
- Get an electrical power drill.
- Power it on and start to drill a hole to the core of the lock.
- Now push the lock using a screwdriver.
- This will break the lock, and you can now open the mailbox.
How do I pick the lock on my mailbox?
Once the lever is inside the lock, press the long end of the lever in the direction you would turn the key to unlock your mailbox. While you’re picking the lock, continue to press the lever in this direction to apply pressure to the barrel of the lock.
How do you unlock a mailbox with a paper clip?
Bend down the bent curve until it’s at a 90-degree angle from the rest of the paper clip. Insert the short side of the lever into the lock. Hold the long end of the lever between your fingers. Once the lever is inside the lock, press the long end of the lever in the direction you would turn the key to unlock your mailbox.
How do I open my mailbox when it won't open?
Remove the lever and the lockpick from the lock and open the door to your mailbox. How can I open my mailbox when it won't open with a key? Try some WD-40 with a red hose nozzle and spray into the lock. Then wait for a few minutes before trying to use your mailbox key.
How do you unlock a door lock with a lever?
Use the lever to rotate the barrel to unlock the lock. Once you’ve raised all 5 pins, the barrel of the lock should immediately rotate since you’re applying pressure to it with the lever. Finish rotating the barrel all the way with the lever until the lock is unlocked.
How do you unjam a mailbox lock?
Repeatedly heat the keyhole and the key, holding it under the hair dryer for 20 to 30 seconds. Try the key in the mailbox until the ice loosens and you are able to work the lock. Do not force the key into the lock, or force the key to turn, as this can cause your key to break.
What do you do when your mailbox key doesn't work?
Go in person to the post office for your address. The postal clerk will let you know. If it's a USPS mailbox and your key no longer works, you can get a new lock & keys installed free of charge. The window clerk will put you on a list: it takes about two weeks for lock replacement.
How do you open a jammed lock?
0:493:14How to free a stuck lock or padlock. Rusted lock? No problem. No ...YouTubeStart of suggested clipEnd of suggested clipSo you can put antifreeze in there and when it's frozen up you can also put lubricant in there orMoreSo you can put antifreeze in there and when it's frozen up you can also put lubricant in there or graphite. And a lot of people will swear by graphite.
Why won't my key turn in the lock?
The Key Won't Turn If your key doesn't turn in the lock, the problem may just be a poorly cut key. Test the lock with a key that was cut at a different time to be sure. If the key isn't the problem, try lubricating the lock using powdered graphite or a silicone-based lubricant.
Are mailbox keys universal?
The Postal Service uses a universal key, known as an arrow key, to access collection boxes, outdoor parcel lockers, cluster box units, and apartment panels. Supervisors assign these keys – generally one per route – to letter carriers for use on over 300,000 delivery and collection routes each day.
How do you open a locked mailbox without a key?
0:121:37How To Open Your Mailbox WITHOUT a Key - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd we're gonna gently pry the door. Open. Now that I have it pried open I'm able to stick my hammerMoreAnd we're gonna gently pry the door. Open. Now that I have it pried open I'm able to stick my hammer the claw end inside of the mailbox. Now you can see here I've removed the screwdriver.
Why is my lock jammed?
Opt for a dry lubricant Debris is a major cause of jammed locks. Keep dust and dirt away from the keyhole and entire lock mechanism by using a dry lubricant instead of an oil-based one. Teflon or graphite lubricants are great options.
How do you open a door when the mechanism is broken?
Use a screwdriver to loosen the screws on the door handle. If this is too tight, it can pinch the spring and prevent the mechanism from working. By loosening this, you may be able to open the door.
How do you loosen a stiff lock?
0:253:37How To Fix a Sticky Lock | Mr. Locksmith™ Video - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo again wd-40 for sticky locks. Don't it'll unstick it but it's not going to lubricate it. So yetMoreSo again wd-40 for sticky locks. Don't it'll unstick it but it's not going to lubricate it. So yet what you have to do the Tri flow will lubricate the lock perfectly.
Will WD-40 unfreeze a lock?
Q: WD-40 shouldn't be used in door locks or ignition locks. It dries out and turns to goo, which can cause the tumblers to stick. It was initially meant as a de-rusting spray and general-purpose lubricant (say, door hinges). Locksmithsrecommend using Teflon spray lubricant inlocks now.
Is it OK to put WD-40 in a lock?
The simple answer is you should not use WD40 to lubricate locks. WD-40 is one of the solvent-based lubricants and does not contain any lubricant and over time can make your lock even stickier by gumming the lock up.
How to open a mailbox with a key?
1. Insert the short side of the lever into the lock. Hold the long end of the lever between your fingers. Once the lever is inside the lock, press the long end of the lever in the direction you would turn the key to unlock your mailbox. While you’re picking the lock, continue to press the lever in this direction to apply pressure to the barrel ...
How to make a lockpick out of 2 paper clips?
Fashion a lockpick and lever out of 2 paper clips if you don’t have hairpins. To make the lockpick, straighten out half of the paper clip, leaving the other half as is. Then, bend the end of the straightened half of the paper clip upward slightly . To make the lever, straighten out the second paper clip almost all the way, ...
How to make a lockpick with hairpins?
2. Make a lockpick and lever using 2 hairpin s if you don't have a kit. To create the lockpick, bend one of the hairpins so the ends are 90-degrees apart and remove the rubber caps from the ends. Then, slightly bend one of the ends of the hairpin upward so the end is no longer perfectly straight .
What to do if a lockpick is seized?
If it’s not seized, push it up and continue onto the second pin. If it is seized, wiggle the lockpick up and down to force the pin up above the barrel. You’ll hear a click whenever a seized pin is raised up all the way.
How to hear a click on a pin?
You’ll hear a click whenever a seized pin is raised up all the way. Continue lifting the pins up until all 5 have been raised. Each time you lift up a pin with the lockpick, push the lockpick into the lock a little further to find the next pin. If you encounter a seized pin, force it upward using the lockpick.
How many pins are in a lock?
Inside the lock, there are 5 pins that need to be raised to the same height in order for the barrel of the lock to turn and unlock the lock. You’ll use the bent part of the lockpick to lift the pins to the right height. When you insert the lockpick into the lock, keep it close to the opening of the lock.
Why use a lockpicking kit?
Using a lock-picking kit will save you time and make it easier to get your mailbox unlocked. Lock-picking kits come with multiple lockpicks and levers to choose from, so you have options in case something doesn’t fit in your mailbox lock.
How to open a locked mailbox?
Insert the hairpin into the lock. Click to see full answer. Considering this, how do you open a locked mailbox? Hold the long end of the lever between your fingers. Once the lever is inside the lock, press the long end of the lever in the direction you would turn the key to unlock your mailbox. While you're picking the lock, continue to press ...
How to make a lock with a hairpin?
Steps: At first, take manicure scissors or a small thin knife. Insert the thin end of the tool into the lock hole. Turn the lock as like the key. Turn it slowly until the door open. If the above methods don't work, then you can try with a thin hairpin. Insert the hairpin into the lock. Click to see full answer.
How to get replacement keys for lost keys?
After losing both of the initial keys, you can request a replacement by submitting an United States Postal Service form 1094 and by paying the refundable key deposit as well as a key fee. If you still have your keys, but they're worn or damaged, you can bring them to the post office and have them replaced for free.
