Changing Honda Foreman 500 Oil
- Run the motor on idle for a minute to warm the oil, then remove the access panel cover from the left side panel, and remove the dipstick to ...
- Position a drain pan under the engine, and remove the 17mm drain bolt and crush washer from the bottom of the engine. ...
- Let the old oil fully drain, then reinstall the crush washer and drain bolt, and torque the bolt to 18 foot-pounds.
- Remove the seat and the right-side fairing to access the oil filter.
- Remove the three 8mm bolts and the oil filter cover. Next, remove the old oil filter and install the new filter. ...
- Inspect the O-ring around the oil filter cover and replace it if necessary. Reinstall the oil filter cover, and tighten the bolts to 7 foot-pounds. ...
- Refill the engine with 3.2 quarts of Honda GN4 10W-30 oil or any 10W-30 oil designed for a wet clutch system.
- Reinstall the dipstick, and idle the motor for about 15 seconds to circulate the new oil throughout the engine. ...
- Remove the dipstick, wipe it clean, then set it back into the crankcase without threading it back in. Remove the dipstick again and check the oil level. ...
- Honda Foreman 500 Oil Change. ...
- Position a drain pan under the engine, and remove the 17mm drain bolt and crush washer from the bottom of the engine. ...
- Remove the seat and the right-side fairing to access the oil filter.
- Remove the three 8mm bolts and the oil filter cover.
Does the Honda Foreman ATV have an oil change process?
The Honda Foreman ATV is a suitable hunting ATV as well as a rancher. The engines in the Honda Foreman will vary from model to model, but the oil changing process is the same for all of the Honda Foreman ATV line.
How do you drain the oil in a Honda Foreman?
Park the Honda Foreman on flat ground and leave the engine running for 5 minutes to allow the engine to warm up. Place the oil drain pan under the crank case drain plug. Turn the engine off. Remove the drain plug from the under side of the crank case using the ratchet set. Allow the engine oil to drain into the oil pan.
How do you put oil in a Honda 4-stroke?
Insert the funnel into the hole where the oil cap was. Pour Honda 4-stroke engine oil into the funnel until the oil starts to come out of the hole where the small screw was on the side of the crank case.
How do I change the oil in my Honda CRV?
Remove the small screw from the side of the crank case using the Allen wrench. Remove the cap labeled "OIL" from the top of the crank case. Insert the funnel into the hole where the oil cap was.
Does a Honda Foreman have an oil filter?
Honda 15412-HM5-A10 Oil Filter.
Where is the oil filter on a Honda Foreman S?
1:114:21Honda Foreman 500 oil and filter change - YouTubeYouTubeStart of suggested clipEnd of suggested clipThis was located on the right side of the bike.MoreThis was located on the right side of the bike.
What kind of oil does a Honda Foreman take?
Honda GN4 10W-403 Quarts of Honda GN4 10W-40 4-Stroke Motorcylce Oil.
Where is the oil filter on a Honda Foreman 520?
10:0817:262021 Honda Foreman 520 - 100 Mile Oil Change! - YouTubeYouTubeStart of suggested clipEnd of suggested clipIt's in the manual right here all right the oil filter cover is seven foot pounds.MoreIt's in the manual right here all right the oil filter cover is seven foot pounds.
Where is the oil filter on a Honda 4 wheeler?
1:053:43Honda ATV Oil Filter - Which Way Does It Go? - YouTubeYouTubeStart of suggested clipEnd of suggested clipNow the old filter cover is located on the right hand side of the engine. Or zoom in here and get aMoreNow the old filter cover is located on the right hand side of the engine. Or zoom in here and get a little closer look at it.
Where is the oil filter on a Honda Foreman 500?
Honda Foreman 500 Oil ChangeHonda Foreman 500 Oil Change. ... Position a drain pan under the engine, and remove the 17mm drain bolt and crush washer from the bottom of the engine. ... Remove the seat and the right-side fairing to access the oil filter.Remove the three 8mm bolts and the oil filter cover.More items...
How many quarts of oil does a Honda Foreman take?
3 Quarts3 Quarts of Honda GN4 10W-40 4-Stroke Motorcylce Oil. **Kit includes One Genuine Honda OEM Oil Filter and One Crush Washer.
Is 10w30 OK for ATV?
The second number that follows is the hot viscosity. It is advised to respect it. The engines are machined so that the chosen viscosity is most effective. In the example recommendation above, the manufacturer requires grade 10w30, so depending on the start temperature, 0W30, 5W30 or 10W30 would be good choices.
What kind of oil filter does a Honda Foreman 450 take?
Honda 17254-HC5-900 Air Filter.
How do you reset the oil light on a Honda Foreman?
The reset procedure is the same for most Honda four-wheelers.Turn the ignition on without starting the engine. Video of the Day.Press and hold the trip meter select button.Press and hold the "Reset" button.Release both buttons after the oil light disappears. you may like. How to Change Oil on an MTD Snowblower.
How do you change the oil on a 2008 Honda Foreman 500?
0:032:45How to Change the Oil on a Honda Foreman 500 - YouTubeYouTubeStart of suggested clipEnd of suggested clipThe first thing we need to do is remove the access cover to give us access to the dipstick. And thenMoreThe first thing we need to do is remove the access cover to give us access to the dipstick. And then unthread the dipstick. This will help the crankcase event properly.
How much oil does a Honda Foreman Rubicon take?
5 Quarts of Honda GN4 10W-40 4-Stroke Motorcylce Oil. **Kit includes One Genuine Honda OEM Oil Filter and One Crush Washer.
How to warm up a Honda Foreman?
Step 1. Park the Honda Foreman on flat ground and leave the engine running for 5 minutes to allow the engine to warm up. Place the oil drain pan under the crank case drain plug. Turn the engine off.
What is a Honda Foreman?
A Honda Foreman is an All Terrain Vehicle (ATV) that is set up for heavy off-roading. The Honda Foreman has locking differentials which allow this ATV to go from rear wheel drive to 4 wheel drive. The Honda Foreman ATV is a suitable hunting ATV as well as a rancher.
How to remove the drain plug from the crank case?
Remove the drain plug from the under side of the crank case using the ratchet set. Allow the engine oil to drain into the oil pan. Replace the plug to the bottom of the crank case and tighten the plug using the ratchet set.
Does the Honda Foreman have the same oil?
The engines in the Honda Foreman will vary from model to model, but the oil changing process is the same for all of the Honda Foreman ATV line. The type of engine oil is the same for all as well, but the amount that is used will be different for different engine sizes.
