Changing the Belt Disconnect the black wire from the battery terminal, and then disconnect the red wire. Grab the drive belt with both hands, one hand on each side of the idler pulley.
How do you replace drive belt on Cub Cadet?
Apr 13, 2021 · A diy, step by step video demonstration on Replacing the Drive Belt for the hydrostatic transmission on a Cub Cadet XT1 lawn mower.#drivebelt #cubcadet #XT1...
Why is my Cub Cadet lawn mower hard to start?
Jan 17, 2020 · Grab the drive belt with both hands, one hand on each side of the idler pulley. Move the double-idler bracket forward slightly. Pull the drive belt off of the idler pulley and the double-idler bracket. How does a belt go on a Cub Cadet riding mower? Put the belt covers back on the outer pulleys. Slide the cutting deck back under the mower. Route the deck belt around the …
What size belt for Cub Cadet?
Apr 14, 2020 · Route the deck belt around the engine pulley and secure the belt keeper rod. Insert the click pin into the front deck hanger rod. Likewise, people ask, how do you tighten the belt on a Cub Cadet? Turn the ratchet toward the right side of the mower to loosen the belt tension on a 46-inch deck. If your Cub Cadet lawn tractor has a 50-inch deck, set the 3/8-inch drive ratchet to …
How to remove a mower deck from a Cub Cadet?
Sep 21, 2019 · This video shows how I replaced the transmission drive belt on my Cub Cadet LT42 XT1 Enduro series mower. I cover:1. Taking off the drive pulley (0:00)2. Cle...
Step 1
Park the tractor on a level place. Remove the mowing deck and place the front wheels on blocks or jack up the front end. Place wooden blocks behind the rear wheels to ensure the tractor doesn't move while it's being serviced. Disconnect the battery cables, removing the negative contact first.
Step 2
Detach the PTO electrical harness underneath the engine. Loosen and remove the hex nut from the electric PTO clutch. Lower the PTO clutch nut off the crankshaft, making sure not to lose the nut or any accompanying washers.
Step 3
Remove the old belt from the tensioner, or fixed V-idler, pulley. This round pulley is located midway between the PTO clutch and the transmission. Pull down on the engine pulley, which is located on the driveshaft, and remove the belt from the engine pulley. Continue unlooping the old belt from the pulleys.
Step 4
Place the new belt on the transmission pulley first. Take care not to bend the transmission fan blades. Loop it back through the other pulleys in the reverse order in which it was removed.
Step 5
Place the PTO hex bolt and any washers that were on the shaft back in place and tighten the bolt. Replace the mowing deck. Reconnect the battery cables, connecting the positive cable first. Lower the front end off the blocks or jack.
