- Connect the power, press the ON/OFF button on the remote controller to turn the unit on.
- Use the MODE button to select COOL, HEAT, AUTO and FAN to check if all the functions work well.
- When the ambient temperature is too low (lower than 17°C), the unit cannot be controlled by the remote controller to run in cooling mode. ...
Full Answer
How do I get my air conditioner serviced by Kelvinator?
To contact you local Service Repairer who is authorised by Kelvinator to service you Air Conditioner, please contact our Customer Care Centre on 130039363640 or 131349 to make a booking. Things you need to consider: Air flow, clearance around the indoor and outdoor unit, direct sun light, noise reflection, weather and ease of access, etc....
How long is the warranty on a Kelvinator air conditioner?
For a domestic application: all Kelvinator Air conditioners come with two years full manufacturer's warranty, and an extra three years if the unit is installed by a licensed installer. Can Kelvinator Air Conditioner provide warranty for commercial application?
How do I know if my aircon remote is working?
There seems power to the air con still as if you turn off the aircon via the switch near the outdoor unit then turn it on again, the indoor unit does make a small sound stating that it is powered. The remote seems to be ok as if you press the on button the display still works showing the temperature etc.
How do I switch from cooling to heating on the thermostat?
If it is a button and not a toggle switch, pressing it to one beep should operate cooling mode, pressing until two beeps are heard will change to heating I believe, or at least some similar combination.
How do I turn on my aircon?
0:383:32How to turn On/Off LG Split AC without a remote (Inverter and Non-Inverter)YouTubeStart of suggested clipEnd of suggested clipSo first off you will need to make sure that the power is turned on then. Open this flap manually.MoreSo first off you will need to make sure that the power is turned on then. Open this flap manually. And you will see a little button over here. So press on this to turn the air conditioner.
How do you use Kelvinator aircon?
Connect the power, press the ON/OFF button on the remote controller to turn the unit on. Use the MODE button to select COOL, HEAT, AUTO and FAN to check if all the functions work well.
Where is the reset button on a Kelvinator air conditioner?
0:141:35How to Reset Your Air Conditioner Unit | Easy! - YouTubeYouTubeStart of suggested clipEnd of suggested clipIf it doesn't have an isolator you can do this from the circuit breaker in the Power Board just aMoreIf it doesn't have an isolator you can do this from the circuit breaker in the Power Board just a matter of flicking that off what that does is it turns the power off to the system.
Why is my Kelvinator air conditioner not working?
Check that the isolation switch and/or circuit breaker are switched on at the switchboard and check that the fuse is pushed in correctly. If the circuit breaker is tripped or the fuse is blown a service call should be booked.
How do you turn on Kelvinator AC without remote?
1:342:40how to turn on air conditioner without remote & with remote - YouTubeYouTubeStart of suggested clipEnd of suggested clipOff you must press this um yellow switch once again this power switch one second i'm going to press.MoreOff you must press this um yellow switch once again this power switch one second i'm going to press. Now you can see that uh our ac i've been turned.
How do I turn off Kelvinator aircon?
Maximum setting is 30°C. 1 ON/OFF Button Press this button, the unit will be turned on, press it once more, the unit will be turned off. Sleep function will be cancelled while the unit is switched off. 2 MODE Button By pressing this button, Auto, Cool,Dry, Fan, Heat mode can be selected progressively.
What would cause an AC unit to not turn on?
Several thermostat issues can cause your air conditioner not to turn on. One of the most common problems is disconnected or lose wires. If the wires are frayed, not connected, or dirty, your air conditioner will not be able to turn on. Another common problem is a faulty thermostat.
Why is my air conditioner not working?
If your air conditioner is not working, it can be caused by a variety of reasons. Common reasons include dirty or blocked air filters. In other cases, there can be issues with your compressor or refrigerant. This can lead to your ac not blowing air, not turning on, or it just doesn't seem to be working properly.
Why is my AC outside unit not turning on?
Usually when the outdoor unit doesn't turn on, it is because something tripped the circuit breaker. When this happens, you can easily reset it after locating the circuit breaker panel. If you find that the AC unit still does not work, the next place to look is the thermostat.
Where is the reset button on the air conditioning unit?
Look for it first around on the exterior of your machine, especially along the bottom edge near the ground. An AC's reset button is typically red and visible, so it should be easy to spot. If you don't see a reset button on the outside, it could be located inside the unit behind the service panel.
How long should an indoor fan cycle?
In cold conditions at 10°C or below, if connecting pipe length is above 7.5m, the indoor fan could cycle every few minutes until the indoor coil remains above a specific temperature. This condition should only last for a few minutes. LED / light is flashing and the unit is not working.
Can a gas continuous unit be switched off?
The power to the gas continuous unit may be switched off or the connecting wires from remote to unit are not connected. Steam/Vapour. Vapour or steam coming from the hot air outlet of the unit. This is normal and can happen on cold or wet days as the unit can generate steam or vapour when the unit is heating.
How to contact Kelvinator service?
To contact you local Service Repairer who is authorised by Kelvinator to service you Air Conditioner, please contact our Customer Care Centre on 130039363640 or 131349 to make a booking. Choosing the correct location for the indoor and outdoor unit.
What is window wall air conditioner?
Window wall: a self-contained packaged air conditioner. All components are housed within the unit. It is relatively easy to install through a wall and no inter-piping connection is required. However, the unit might be slightly noisier compare to a split system, as the compressor is mounted within the unit.
How to reduce running costs of refrigerator?
How do I reduce the running costs and save energy of the refrigerator? A few things can be done to save on energy consumption. Do not operate the freezer too cold. Allow hot foods to cool to room temperature before placing into the freezer compartment. The door gasket should seal to the cabinet when the door is closed.
What factors should be considered when installing an outdoor unit?
Factors you need to consider: pipe work, electrical wiring, distance in between the indoor and outdoor, is the outdoor unit going to be installed on the ground or up high. Your licensed installer would be able to advise you upon site inspection.
Do you block air vents in freezer?
Do not block air vents, this will cause the unit to run for longer, and therefore use more energy. If the freezer compartment is filled to capacity, the food mass will help maintain freezer temperature when the doors are being opened.
Can you install a solar hot water tank internally?
The tank of your Solar unit can be installed internally but be careful with this as most new hot water systems are much larger than the existing system. You will need to check the dimensions of the tank if it is in a tight spot e.g. corner of laundry.
Does an air conditioner remove heat?
Air conditioners remove both heat and humidity from the air (in cooling mode). If the unit is too large, it will cool the room quickly, but only remove some of the humidity. This leaves the room with a damp, clammy feeling.
