- Turn off the power to the furnace at the circuit breaker. The circuit breaker is clearly marked.
- Lift up the blower compartment cover to access the blower wheel and blower motor.
- Look for a small red or yellow button on the side of the blower motor.
- Press the reset button down if it has popped up.
Full Answer
How do you reset a Luxaire electric furnace thermostat?
Locate the dedicated circuit breaker for your Luxaire furnace in the electrical service panel of your home after you turn off the furnace thermostat. Flip the circuit breaker off. then turn it back on. Reset the thermostat and wait for the furnace to restart. Always On. Always Open. 100% Digital.
How do I troubleshoot a Luxaire furnace?
Troubleshooting a Luxaire furnace is relatively simple and may help identify and resolve any problems. Ensure the furnace is properly connected to a working power supply and the gas valve is open if the furnace is not operating. Check and restart local fuses or circuit breakers if applicable.
Where is the dedicated circuit breaker for my Luxaire furnace?
Locate the dedicated circuit breaker for your Luxaire furnace in the electrical service panel of your home after you turn off the furnace thermostat. Flip the circuit breaker off. then turn it back on.
Are Luxaire furnaces energy-efficient?
eHow may earn compensation through affiliate links in this story. The Luxaire Company manufactures a variety of heating and cooling products for homes and businesses, including air conditioners, water heaters and furnaces. Luxaire furnaces offer high efficiency heating and many carry the Energy Star label.
What is a Luxaire furnace?
The Luxaire furnace is a gas-powered home appliance. The Luxaire Company manufactures a variety of heating and cooling products for homes and businesses, including air conditioners, water heaters and furnaces. Luxaire furnaces offer high efficiency heating and many carry the Energy Star label.
How to turn off gas on a furnace?
Turn off the electrical power and open the front access door. Turn the gas control switch to "Off" and wait 5 minutes to allow any gas to exit the system. Smell carefully for gas and proceed after 5 minutes if no gas is detected. Turn the gas control switch to "On" and close the front access door. Restore electrical power. If the pilot light does not stay lit, turn off the furnace and contact an authorized service technician.
Why does my Luxaire furnace light up red?
Luxaire furnace blinking red light six times means that the pressure switch opened four times throughout the heat request after the furnace operated. When the primary blower is in “delay on” mode, it will complete it, along with all subsequent delay-off periods.
Why does my Luxaire furnace have four red flashes?
Luxaire furnace four red flashes signify that an auxiliary/primary limit switch has opened its typically closed contacts. When this code develops , the control will run the inducer and the supply air blower. Wrongfully sized duct system, dirty filter, wrongfully firing rate, improper blower speed setting, or defective blower motor make possible causes for the problem.
