- Existing Plumbing Stub-Outs. The most efficient and least expensive method of installing a basement shower without the need to break concrete is to install it over existing plumbing stub-outs.
- Up-Flush Drainage System. An up-flush drainage system features a pump that removes sewage from a holding tank located behind a toilet, tub or shower and pumps it into the home's ...
- Elevated Shower Base Required. To allow adequate drainage from the shower to an up-flush system, the shower must be elevated. ...
- Up-Flush Drainage System Considerations. Basement ceilings are typically lower than other ceilings in the house, and when you add an elevated shower, you'll further reduce headroom in the shower stall.
How do you install a shower in the basement?
Trench the Floor
- Start breaking up the basement floor at the main line with a sledgehammer. Note: Breaking through at the tie-in point may take a few dozen whacks.
- Pick out the larger chunks of concrete as you go.
- Toss the dirt in a pile separate from the larger chunks of concrete. Note: You don't want big chunks in the soil you'll use for backfill later.
How to install shower in basement without breaking concrete?
In what order should I finish my basement?
- Install Insulation.
- Frame the Walls.
- Install Utilities.
- Mount Drywall.
- Paint.
How to install a shower in your basement?
Installing a Basement Shower
- Locate Drain. Locate the drain that was originally installed when the concrete for your basement was poured during its construction.
- Design Basement Shower. Design your basement shower, making sure that it is easily accessible not only for you, but everyone in your household.
- Begin Basement Shower Construction. ...
- Vent Shower Drain. ...
- Frame Support Structure. ...
How to make a shower base with concrete?
Steps
- 1 Check the floor is level. Start by making sure the shower base is level before laying the screed. ...
- 2 Measure the shower base for your wedges. The next step is to make timber wedges, so that the shower water runs down into the plug. ...
- 3 Measure the wood to make a wedge. ...
- 4 Cut your wedges. ...
- 6 Mix the screed. ...
- 8 Apply the screed. ...
Can you install a basement bathroom without breaking concrete?
Basement Shower (or Bathtub) Installation You can tie a bathroom tub or shower into an upflush toilet system, which eliminates the need to break into the concrete floor. The system sends the wastewater from the shower drain and toilet to a holding tank before being pumped to the main sewer line.
Can you build a shower in the basement?
In a home where the main drain is above the basement floor level or in a basement with no basement drain provisions, you can still add a shower without breaking any concrete. The answer is installing an up-flush drainage system. Such a setup pumps the water from the shower into your home's main drain.
How do you install a shower on a concrete slab?
0:0228:01Installing a Curbless Shower on a Concrete Slab - YouTubeYouTubeStart of suggested clipEnd of suggested clipWe can tell write it to the pipe with the tile and and we'll ground it and finish the floor. We'llMoreWe can tell write it to the pipe with the tile and and we'll ground it and finish the floor. We'll cut this off flush and the flange will sit inside the pipe. The four inch pipe.
Can you put a bathroom in a basement without rough in?
Are you adding a basement bathroom to a new house or an old house? Usually, older homes won't come with a rough-in. If your basement isn't set up to include the necessary systems like drains and plumbing vents, you will need to have them added.
Is it worth putting a shower in the basement?
A basement is a perfect place to add that extra bathroom. Ideal for families with teenagers or a different place to spread out and have some quiet “me time.” Adding a bathroom to your basement, particularly with a shower will increase your property value if done properly.
How do you install an upflush shower?
0:005:41SANIFLOOR: a walk in shower anywhere! - YouTubeYouTubeStart of suggested clipEnd of suggested clipCut off the drainage pipe from your old installation. And seal the hole position the pump in theMoreCut off the drainage pipe from your old installation. And seal the hole position the pump in the required location and locate the position of the gulley.
How do you install a shower pan on a concrete basement floor?
0:0030:26How to install a Mortar Shower Pan on concrete. Pre slope/ Pre pitchYouTubeStart of suggested clipEnd of suggested clipIf this were a traditional shower with a vinyl liner. This would be considered your pre slope.MoreIf this were a traditional shower with a vinyl liner. This would be considered your pre slope.
What do you put under shower base?
Mortar is recommended to use under all shower pans. Mortar reduces the risk of your pan slipping or cracking from an uneven surface.
How do you install a shower tray on a concrete floor?
2:263:39Installation of a shower tray onto a concrete base - YouTubeYouTubeStart of suggested clipEnd of suggested clipApply a sand and cement mix to the base as evenly as possible ensuring all areas are covered.MoreApply a sand and cement mix to the base as evenly as possible ensuring all areas are covered. Carefully place the tray into position and adjust accordingly to ensure the tray is level on all sides.
How do you install a bathroom in an unfinished basement?
0:119:42How to Install a Basement Bathroom (Awesome Quick Tips) - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo let's dive in the first step for us was to determine. How unlevel this bathroom floor was so weMoreSo let's dive in the first step for us was to determine. How unlevel this bathroom floor was so we place a four-foot level on the floor. We screwed holes into the concrete. And then we added tap cons
How much does it cost to add a bathroom in a basement?
$8,000 to $15,000Adding a bathroom in a basement costs $8,000 to $15,000 on average. You'll save $500 to $1,000 if you have a rough-in drain already in place – typical in newer homes and usually near the main drain line.
How much does it cost to add a half bathroom in the basement?
A half bath installed in the basement provides a more conveniently located bathroom out of the usual foot traffic. Also, the average cost to add a basement is around $10-15,000. However, if you add the basement under an existing bathroom, you can save anywhere between $1-2,000 in plumbing expenses.
Where is the plumbing stub out in the basement?
If your contractor made provisions during construction for adding a bathroom in the basement of your home, you'll find plumbing stub-outs in the floor of the basement that will accommodate hooking up a shower, sink or commode. In a home where the main drain is above the basement floor level or in a basement with no basement drain provisions, ...
How much slope is needed for a shower?
The standard slope required on a water drainage pipe is 1/4 inch per linear foot of pipe. Creating room for the drain slope, as well as for a P-trap installed in the drain line beneath the shower, necessitates using an elevated shower base.
Can you put a collection tank behind a toilet?
The collection tank may be integrated into a special toilet, or you can install a tank behind a bathroom wall to keep it out of sight. You'll need access to an electrical outlet to run the pump, and the system must connect to the main drain and to the home's plumbing vent system.
Do basement showers have to be higher than other ceilings?
Basement ceilings are typically lower than other ceilings in the house, and when you add an elevated shower, you'll further reduce headroom in the shower stall. Keeping in mind the height limitations of all who will use the space, consider the location when you install a basement shower.
Is it better to keep plumbing fixtures close to the shower?
Generally, it's better to keep plumbing fixtures close to the shower, sink or commode. The farther away the plumbing fixtures are from the collection tank, the higher the floor of the shower, commode or sink must be to allow for adequate drainage. Advertisement. references. HomeAdvisor: How Up Flush Toilets Work.
Install a Basement Bathroom Shower Without Damaging Your Concrete
The best way to install the shower in a basement bathroom without damaging your floors is to look into an upflush toilet system.
Advantages of Upflush System
Upflush toilets are the best solution to basements and tight bathrooms. Within these spaces, standard gravity-based systems can be troublesome because they cannot handle waste below sewer lines like in your basement or laundry room.
Where is the PVC drain on a Sanicompact?
The PVC on the right is toilet drain going up from the back of the Sanicompact and then slopping downwards. In the background on the left, you can see where it lines up with the ABS-main-stack connection. The coupling is not in place yet. A better shot of the PVC to ABS coupling.
How to install Saniflo Sanicompact?
Step 1: Prepare the Saniflo Sanicompact for installation. Attach all the fittings you’ll need so that any measurements you take will be accurate. The Sanicompact ships by default with the sink connection sealed. You’ll need to cut the cap and attach the drain connector if you plan on adding a sink (like we did).
How to Install Toilet in Basement without Breaking Concrete
The space you decide to start this type of renovation must correspond closely to your existing installation. This means installation on existing water pipes. This decision will most affect how much you have to spend.
Upflushing System Installation
The up flush system also protects you from damage to precast concrete and makes it easy to get the features you need. When it comes to conventional bathrooms, the best place is always right next to the existing bathroom. The easiest and most economical way to place a bathroom in the basement is under the top.
Advantages of the Upflush system
Upflush toilets with elevated water levels are the best solution for cellars and cramped bathrooms. Standard gravity systems can be problematic in these areas because they cannot process waste under sewer lines, such as in your basement or laundry.
Frequently Asked Questions
You can install the toilet on a concrete floor. It may sound intimidating, but installing a new toilet can be a do-it-yourself project you can be proud of.
Conclusion
A toilet in the basement is necessary to your basement bathroom, but installing one is an entirely different affair. In this case, the water supply system will only be able to operate. It is under the influence of gravity and above ground. In most cases, you can connect directly to the existing “underground” sewer, and you can go.
