Proceed to reset the throttle control by first releasing the gas pedal of any pressure. To do this, turn on the ignition for not more than 2 seconds before turning it off for 10 seconds. Ensure that you do not ignite the engine. Turn on the ignition again for another 2 seconds and then turn it off again and wait for another 10 seconds.
Full Answer
How do you reset service electronic throttle control manually?
Resetting your electronic throttle control manually can be a tricky job. First, make sure the accelerator pedal is fully released. Next, turn the ignition on and then turn it off and wait for ten seconds. During these ten seconds, be sure the throttle valve is moving by listening for a sound of operation.
How do you reset the electronic throttle control sensor?
The easiest way to reset your throttle position sensor is to unhook the negative cable from your battery for up to five minutes or to remove the fuse for your engine control module.
What does it mean when it says service electronic throttle control?
solution: this indicates a serious failure of your throttle control system. the engine computer is programmed to go into limp mode when the system malfunctions, in an attempt to limit your speed and prevent damage to the engine. it can be caused by a sensor failure, or even by outside electromagnetic interference.
How do you reset the TPS on a Dodge Ram?
With your engine off, turn the key to the “On” position, but don't start the vehicle. Hold the TPMS reset button until the tire pressure light blinks three times, then release it. Start your car and wait 20 minutes for the TPMS sensor to refresh. The TPMS reset button is usually located beneath the steering wheel.
Is there a fuse for electronic throttle control?
The power provided to the electronic throttle actuator is regulated by the actuator relay in the underhood fuse panel. It acts as a switch, sending power to the throttle actuator when it is required.
Where is the electronic throttle control located on a Dodge Ram?
You will first open the engine hood and locate the throttle control part. You will find it on top of the car engine, where it connects the air filter.
What does red lightning bolt mean on Dodge Ram?
The lightning bolt on the dash means that there is a problem with the electronic throttle control system in your vehicle. Get a code reader and scan the engine for any logged codes. The light may be on for a glitch and the electronic throttle control system needs to be reset.
What can cause the electronic throttle control light to come on?
The most common causes of an electronic throttle control light are a faulty throttle control sensor or a faulty throttle accelerator pedal position sensor. But while those are the most common causes of an electronic throttle light, they aren't the only things that could be going on.
What controls the throttle on a 6.7 Cummins?
The throttle control valve is located between the intake manifold and intercooler pipe on the drivers side of the engine and features a butterfly valve that has been known to get contaminated with soot and freeze up.
Where is the TPMS reset button on a 2012 Dodge Ram?
1:563:552012 Ram Truck | Tire Pressure Monitoring System - YouTubeYouTubeStart of suggested clipEnd of suggested clipThe tire light load switch is located on the instrument panel above the climate controls.MoreThe tire light load switch is located on the instrument panel above the climate controls.
Where is the TPMS reset button on a 2018 Dodge Ram?
A TPMS reset can be done on a 2018 Ram 2500 by putting the key in the ignition and turning it to the on position. Do not start the car. Now press the TPMS Reset button located under the dashboard and hold it until the tire pressure light begins to blink.
How do you turn off the tire pressure light on a Dodge Ram 2500?
Turn your key to the “On” position without turning the car back on. Press the TPMS reset button and hold until the light blinks three times. Release the button. Start the car and drive for 20 minutes to reset the sensor.
Re: Service electronic throttle control
I'm having the same issue. Did you get it fixed? Or dose anybody have any suggestions on this?
Re: Service electronic throttle control
Is the throttle valve unplugged? If not, unplug it as they supposedly throw a code when not used all the time.
Re: Service electronic throttle control
Is the throttle valve unplugged? If not, unplug it as they supposedly throw a code when not used all the time.
JOIN THE TEAM TODAY
IGOTACUMMINS is an online community for all Cummins Turbo Diesel enthusiasts. You'll find an informative tech area, a place for Member’s Journals, Vendors with Special Members Pricing, Plus More! If this is your first visit, click the FAQ regarding our (FREE MEMBER ACCOUNT PRIVILEGES), FAQ and also click REGISTER to sign up.
Thread: Service Electronic Throttle Control
Just got this code driving down the road yesterday. CEL and a lighnting bolt. Truck still operates like normal. Anyone deal with this yet?
How to fix service electronic throttle control
Resetting or servicing your electronic throttle control can be carried out with these two methods, they include;
What is electronic throttle control?
You can think of the Electronic Throttle Control (ETC) as a vehicle technology that has the core function of electronically connecting the gas pedal to the throttle. It also carries out restoring/maintaining the mechanical link within its components and the vehicle engine.
How do I know if my electronic throttle control is bad?
The performance of the ETC can either have a positive or negative impact on the engine and overall vehicle performance. Any of the following can be considered as a possible symptom: