What size fuel line is on a Chevy Cobalt?
The Chevy Cobalt uses a single ⅜” supply line, 1 ⅜” vapor line, and a fuel filter. The fuel lines are made from nylon and measure 7' long.
How do you fix a leaking fuel line connector?
0:0410:40How To Fix Leaking Fuel Lines | ALL Makes And Models - YouTubeYouTubeStart of suggested clipEnd of suggested clipWe have four compression fittings we have a tubing cutter. We have a pick or you can use aMoreWe have four compression fittings we have a tubing cutter. We have a pick or you can use a screwdriver whatever the case we're gonna be using a little hacksaw for metal.
Are fuel lines hard to replace?
Replacing the fuel hose on your vehicle is going to take time and patience, and it could require getting underneath the car. It's also going to take the right tools for the job.
How do you fix a rusted fuel line?
0:219:53Fix Rusted Fuel Lines Without Replacing the Entire Line - YouTubeYouTubeStart of suggested clipEnd of suggested clipWell we obviously got a leaky fuel line so we're going to cut into this fuel line without replacingMoreWell we obviously got a leaky fuel line so we're going to cut into this fuel line without replacing the whole fuel line go down to the parts store with the parts that we take off of it just to make
Can you drive with a leaking fuel line?
It's never safe to drive a car with a fuel leak. Fuel leaks are one of the top causes of vehicle fires. Gas is highly flammable, so it is highly likely that the gas could start a fire, either in the vehicle itself or from the fuel left behind from a leaking vehicle.
Can I use rubber hose to repair fuel lines?
Standard rubber vacuum or heater hose should never be used in fuel applications. The hose will deteriorate from the inside out and can plug fuel filters and carburetors with rubber debris, long before it springs an external leak.
How long does it take to change fuel line?
Regardless what the back yard wonders will tell you how quickly they can do it, I would say that, if the tank does not need to be removed,they will charge at least 2 hours labour. If the tank needs to be drained, removed and reinstalled, add a couple more.
How much does it cost to replace a fuel pipe?
If you need fuel hose replacement, the average cost can vary a lot depending on the make and model, anywhere from $120 to $500 or even more. Older cars are more susceptible to fuel hose leaks as newer models typically use hard fuel lines more often.
How do I install a fuel line?
2:304:35How to Replace the Fuel Line in a Line Trimmer - YouTubeYouTubeStart of suggested clipEnd of suggested clipTo install the line use the scissors. And cut the end of the small line at an angle then push theMoreTo install the line use the scissors. And cut the end of the small line at an angle then push the cut end of the line into the small hole in the tank.
Can you replace metal gas line with rubber?
Yes, you can, but there are some hazards/risks involved with using rubber fuel line. Sealing is a problem when you don't use hose fittings. Just slipping the hose on steel tube is asking for leaks, many times they are not visible. I recommend using double clamps and Hylomar sealant when not using hose fittings.
Can I use JB Weld to fix a fuel line?
JB weld might work. Rough the surface up real good so the epoxy will have something to adhere to. Use brake clean to clean it.
What causes a fuel line to leak?
According to eHow, fuel lines can develop leaks over time because they are prone to rub against metal under your vehicle. Mechanics stress that fuel lines need to be replaced in full and that damaged sections of the line cannot solely be repaired.
Anonymous
This is how you do it. Ensure that the transaxle case temperature is 70° to 90° F (21° to 32° C). With the engine running, shift transmission through all gears. With engine idling in PARK, remove the check plug from the transmission. If transmission has been overfilled, allow fluid to drain out.
Anonymous
There are only 2 things you can try to fix this yourself: turn off the engine and open the driver side door (to turn the radio off). Wait 5 minutes, start your car. If that does not solve it, turn off your engine, disconnect the car battery, wait about 5 minutes.
cy schousboe
Sounds like a load of ------ to me but what are you going to do. The line should be steel and you can make a quick reliable fix. Locate the leak, the line will be attached to the frame, on the inside, probably the driver's side. There will be probably at least 3 lines in 2 different sizes.
Anonymous
i dont think you can just get the chip,its the complete power steering control module ( computer) typical problem withall ions and cobalts
Anonymous
disconecting the battery should reset the pcm. but you will need to find out what caused the problems.
2005 Chevy cobalt got low on fuel,turned it off added fuel,now will not start and can't hear fuel pump run when key is turned on,what and where could problem be
Fuel pump , fuel pump relay , Test fuel system . GM Fuel Pump Relay Testing
Recently i hit some debris on the hiway that hit the fuel tank in my 2005 chevy cobalt. it damaged the fuel pump assembly to where i had to replace the pump. yet i still have no fuel delivery and it still..
Try following the fuel lines from the pump and look for a squashed steel line that is blocking the fuel flow. IT is possible the some wires were damaged from the debris.